Abstract:
Additive manufacturing (AM) is used for the fabrication of solid components of complex geometries for customized applications. However, AM-fabricated components frequently require finishing operations such as abrasive grinding, which causes a different surface characteristic compared to the conventionally manufactured components. Thus, it is essential to study the effect of process parameters and the heat treatment on surface quality of the AM components because these may behave differently to the conventional manufactured components. In this study, surface characteristics of AM samples of Ti-6Al-4V with a cryogenically cooled finishing operation is compared with that of conventionally processed samples. The samples under investigation were fabricated by two different methods, namely, Direct Metal Laser Sintering (DMLS) and conventional processing. The effect of the two processes on surface characteristics, such as microhardness, surface roughness, X-ray diffraction (XRD), and mechanical properties has been studied. The average surface roughness from cryogenic grinding was reduced by 27.25% and 23.15% for the AM, and 30.08% and 29.13% for conventional samples, as compared to dry and moist conditions, respectively. The finished DMLS and conventional samples showed increase of microhardness by 14.07%, 14.27%, 17.54% and 17.48%, 8.06%, 38.68%, in dry, moist, and cryogenic conditions, respectively. In cryogenic conditions, as the DOC and table feed increased, a greater increase in peak broadening was observed. The peak broadening in XRD of finished DMLS components indicates that a significant level of plastic deformation occurred compared to the finished conventionally manufactured Ti-6Al-4V samples, which suggests that the DMLS samples are more sensitive to the finishing process. Compared to dry and moist grinding, cryogenic grinding was found to have the smallest grains in the layer just below the surface. The impact of cryogenic cooling on surface properties of AM Ti-6Al-4V samples is higher as compared to that on conventionally processed Ti-6Al-4V samples.
